Payment & Shipping Terms:
|Vacuum Impregnation Process
|4800mm Dia *2050mm Height
|Impregnation Tank Material:
|Storage Tank Working Tempreautre:
|5-50 Degree Celcius
|Impregnation Tank Flange:
vacuum pressure impregnation plant,
varnish vacuum impregnation machine
Motor Coil Vacuum Pressure Impregnation Equipment , Vacuum Impregnation Process
The vacuum pressure impregnation system are widely used for impregnation treatment of
windings of motors, electrical equipment, high voltage motors, traction motors, special motors,
pump motors, magnetic motors, and transformers.
The equipment is a newly energy-saving equipment, which greatly improves product quality,
reduces production cost, and strengthens competitiveness.
a) The flange of the vacuum varnish impregnation equipment tank is of a misaligned teeth structure.
The teeth are machined.
b) Opening, closing, locking, and unlocking of the tank lid is through the hydraulic mechanism. Its
return signal is controlled by a non-contact proximity switch.
c) the opening angle of the tank lid is that its apex projects over the
inner wall of the impregnation tank.
d) resin supply and return method: bottom resin supply and return.
e) flange sealing: fluorinated silicone rubber lip type sealing ring (normal life: 2 years). There is also
one spare sealing ring.
f) Lid opening safety protection device: the tank
lid is set with a fast opening interlock device. When the non-contact
proximity switch is activated, the lock ring is unfastened and
the tank lid opened after confirmation of no pressure in the tank by a PLC delay.
g) an anti-explosion lamp, an observation window, and a camera which allows observation of the working
process by the display screen;
h) a magnetic overturn remote level controller
i) The tank lid is also set with a soft sealing gear safety valve. (the is no spark at over-pressure situation.)
j) When the inner wall surface of the impregnation tank is treated,
it is coated with the resin that is used to impregnate the products.
(This measure could prevent rusts in the tank inside. The ferric oxide would react with the resin, and further
affect the insulation
performance of the resin.)
Effective size: vacuum pressure impregnation system tank ID Φ4800×h2050mm (straight height)
head: 16MnR; tank body: Q345; flange: 16MnR forged parts
extreme vacuum degree: 50pa
working vacuum degree: ≤500pa (or resin saturation steam pressure)
empty tank air leak rate: ≤0.133pa.m3/s
working pressure: 0.6Mpa
pressurizing medium: filtered dry air;
design temperature: -10℃～80 ℃
installation type: vertical;
weight bearing stand: bear a maximum of 300ton;
Youtube link of Vacuum Pressure Impregnation Process for Motors
Picture of Vacuum Pressure Impregnation System
6. What is a vacuum pressure impregnation (VPI) process for motors?
VPI vacuum pressure impregnation process is to carry out the vacuum impregnation process for motor windings.
First pre dry and cool the parts after moisture removal, place the windings in a vacuum environment, remove
the air and volatiles inside the motor windings, and exert a certain pressure on the impregnated resin solution
after removing the vacuum by relying on the gravity of the resin solution in the vacuum and the capillary
action of the coil, as well as using dry compressed air or inert gas, so that theresinsolution can quickly
penetrate and fill the inner layer of the insulating structure.
In China, VPI is still a batch type insulation impregnation treatment process.
The vacuum impregnation process of the workpiece is carried out in the impregnating tank, and its
drying process is generally carried out in another container or oven. The methods include vacuum
drying, atmospheric stationary drying or rotary drying.
Contact Person: Ms. Ruth
Tel: +0086 15305299442